Confirmation Of Indoor Unit No. Position - Toshiba RAV-SM1103AT-E1 Service Manual

1
SET CL TEST
Push + +
for 4 seconds or more.
2
(← ← ← ← ← Line address)
Using the temperature setup
set 12 12 12 12 12 to the CODE No.
3
Using timer time
4
SET
Push button. (OK when display goes on.)
5
(← ← ← ← ← Indoor unit address)
Using the temperature setup
6
Using timer time
7
SET
Push button. (OK when display goes on.)
8
(← ← ← ← ← Group address)
Using the temperature setup
9
Using timer time
10
SET
Push button. (OK when display goes on.)
11
TEST
Push button.
Setup completes. (The status returns to the usual stop status.)

10-5. Confirmation of Indoor Unit No. Position

1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
Push button if the unit stops.
ON / OFF
2
UNIT LOUVER
Push button.
1-1 1-1
Unit No. 1-1 1-1 1-1 is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
button.
UNIT LOUVER
buttons simultaneously
/
/ buttons, set the line address.
/
/ buttons, set 1 to the line address.
/
/ buttons, set 0000 0000
0000 0000 0000
buttons,
buttons, set 13 13 13 13 13 to the CODE No.
buttons, set 14 14 14 14 14 to the CODE No.
to Individual, 0001 0001 to Master unit, and
0001 0001 0001
– 78 –
0002 0002 to sub unit.
0002 0002 0002