4 Replacement Procedures
4.14 Fan
Removing the Fan
The following describes the procedure for removing the fan (See Figure 4-31).
1. Disconnect the fan cable from the connector CN8770 on the system board.
2. Remove the following screws and remove the fan by raising it up.
• M2.5x4B THIN BIND screw
M2.5x4B
Installing the Fan
The following describes the procedure for installing the fan (See Figure 4-31).
1. Connect the fan cable to the connector CN8770 on the system board.
2. Install the fan on the base assembly and secure it with the following screws.
• M2.5x4B THIN BIND screw
4-46
[CONFIDENTIAL]
THIN BIND
Figure 4-31 Removing Fan
Satellite A50S/TECRA A3X Maintenance Manual (960-534)
x2
CN8770
Fan
x2
4.14 Fan