Draytek Vigor2830 Series User Manual page 343

5. To activate the function of VLAN Tag for VLAN3 setting, check the box of Enable and
type the value (10) for VID setting. Then check P4 and set LAN4 as the Subnet.
6. In the page of LAN >> General Setup, check the Status box of LAN2, LAN3 and
LAN4 and enable the function of DHCP.
For the detailed settings of the network segment, open LAN>>General Setup and click
Details Page. Adjust the settings for your request. Refer to the following figure.
Configuration for VigorSwitch 2240:
1. Open Vlan>>Tag-based Group.
333
Vigor2830 Series User's Guide