Basic Receiver Lcd Screens - Pioneer VSX-29TX Service Manual

VSX-29TX, VSX-27TX, VSX-26TX,
VSX-24TX, VSX-D908S

Basic Receiver LCD Screens

Receiver MAIN Screen
Receiver
0
9
DSP
/ dts
ADVANCED
THX
THEATER
MIDNIGHT DIRECT
8
DIGITAL
LOUDNESS
NR
6
7
1 Receiver MAIN button
Press this button to select the main receiver screen
(above) when the remote control is on the sub receiver
screen.
2 EFFECT +/- button
Use these buttons to increase or decrease the amount of
effect applied in a DSP or Advanced Theater mode.
When the amount of effect is increased in a DSP/
Advanced Theater mode the characteristics of that mode
become stronger and more noticeable. The scale ranges
from 10-90 with 70 as the default setting. First turn on
the DSP/Advanced Theater mode you want (by pressing
the DSP/Advanced Theater button until you get the
mode) and then increase or decrease the amount of
effect.
3
/dts buttons
Press these buttons to put the receiver in the selected
surround sound mode. For more information on the
modes
4 SIGNAL SELECT button
Press SIGNAL SELECT repeatedly to select one of the
following:
ANALOG : To select an analog signal.
DIGITAL : To select a digital signal (DVD/LD, TV/SAT,
CD, MD/TAPE 1, VCR 1, VCR 2).
AC-3 RF : To select an AC-3 RF signal (DVD/LD, TV/
SAT, VCR 1, VCR 2).
AUTO : This is the default. If there are both analog and
digital input signal, the receiver automatically selects
digital.
5 DIRECT button
Switches DIRECT playback on or off. Use to bypass the
tone controls and channel level for the most accurate
reproduction of a program source. It will automatically put
the receiver in STEREO mode for the function being used
for DIRECT playback.
6 LOUDNESS button
Switches the LOUDNESS mode on or off.
7 DIGITAL NR button
Switches the DIGITAL NR on or off (STEREO mode
only).
108
1 2
MAIN SUB
STEREO
EFFECT
STANDARD
3
SIGNAL
SELECT
4
5
8 MIDNIGHT button
Switches the MIDNIGHT LISTENING mode on or off.
9 DSP button
Press repeatedly to select a DSP sound mode.
0 STEREO button
Press to select the STEREO sound mode. In this mode,
sound comes from the front (left and right) speakers only.
Receiver SUB Screen
Receiver
7
TAPE 2 EXTERNAL
MONITOR
5.1CH
6
5 INPUT
ATT.
1 Receiver SUB button
Press this button to select the sub receiver screen
(above) when the remote control is on the main receiver
screen.
2 BASS & TREBLE (+/–) buttons
Use to adjust the high and low frequencies (STEREO
mode only).
3 SYSTEM SET UP button
Use to set up the speaker and sound systems.
4 CHANNEL LEVEL button
Use this feature to adjust the level of individual speakers
during playback of a source.
5 INPUT ATT button
Use to lower the input level of an analog signal that is too
powerful, thus causing the receiver to distort (the
overload indicator will light furiously).
6 EXTERNAL 5.1 CHANNEL button
Use to hook up an external component that can decode
other types of signals and input them into the VSX-29TX.
7 TAPE 2 MONITOR button
Selects the tape deck (or MD recorder, etc.) connected to
the TAPE 2 MONITOR inputs/outputs. Allows monitoring
of a recording as it's being made.
1
2
MAIN SUB
BASS TREBLE
CH SYSTEM
LEVEL
SETUP
3
4