Open Processor Applications; Features; Typical Trane Objects By Equipment Controller Object Worksheet - Siemens Open Processor Owner's Manual

5 5 5 5
A A A A pp pp pp ppli li li lic c c c a a a a t t t t i i i i on on on ons s s s
O O O O v v v v e e e e r r r r vi vi vi vie e e e w w w w
Chapter 5 contains applications, features, and object mapping for all the Trane equipment
controllers supported by the Open Processor. The following topics are included in Chapter 5:
x

Open Processor Applications

x

Features

x
Typical Trane Objects by Equipment Controller
x
Object Worksheet
O O O O p p p p en en en P P P P r r r r o o o o c c c c e e e e ss ss ss sso o o o r r r r A A A A pp en
Open Processor applications are an important part of the energy management capabilities of
your system. Open Processor applications are created using Powers Process Control
Language (PPCL) statements and, in some cases, additional hardware to perform specific
operations or functions. The control configuration and control requirements of your system
are customized into each application by using PPCL. The applications that you can incorporate
into the operation of your system depend upon the Trane equipment controller the Open
Processor interfaces with. For a list of features, refer to the specific Trane controller that
manipulates the Trane equipment controller.
Siemens Building Technologies, Inc.,
Landis Division
ppli li li lica ca ca cat t t t i i i i on pp pp ons s s s on on
CAU U U U T T T T I I I I O O O O N N N N : : : : CA
CA CA
Incorrect point commanding and operation may damage the
equipment controllers that are controlled by this Open Processor.
Points that may be commanded for specific equipment controllers
must not be set to values other than those recommended by Trane.
Refer to Trane documentation for specifics on Trane equipment
controller operations.
5-1