Toshiba Satellite M300 Maintenance Manual page 129

Replacement Procedures
Install the top assembly
The following describes the procedure for installing the cover assembly (See Figure 4-19 to
4-21).
1. Install the top assembly to the base assembly.
NOTE: Be careful not to catch the cables between cover assembly and base assembly.
2. Connect the touch pad flat cable to the connector on the system board.
3. Secure the cover assembly with the following screws from the top of computer.
• M2.0×6.0
4. Secure the cover assembly with the following screws from the back and bottom of
computer.
• M2.0×6.0
• M2.5×10
• M2.5×4.0
• M2.0×3.0 FLAT BIND screw Back
5. Free the cable from cable-drain when through the antenna cable to PCB hole.
Satellite M300 and Satellite Pro M300 Maintenance Manual (960-Q08)
BIND screw Back
BIND screw Back
BIND screw Back
BIND screw Back
x9
x5
x6
x2
x3
4-32