Table of Contents
Advertisement
Initial battery charging
M
Before plugging the phone line into your new phone for the first time,
fully charge the rechargeable battery pack for 15-20 hours
without interruption.
!
1) Place the handset on the base.
2) Make sure that status LED lights. If the LED doesn't light, check to
see that the AC adapter is plugged in and that the handset makes good
Please visit your
authorised Uniden dealer
contact with the base charging contacts,
to obtain an extra battery
pack.
Charging optional battery packs
M
The base unit of your phone is equipped with a compartment for
charging an extra battery pack for use in your handset. You can
obtain an extra battery pack from your authorized Uniden dealer.
1) Position the battery pack so the inner side with contacts is facing up.
Slide the battery pack into the
charging compartment until it
clicks into place. The compartment
has a latch that keeps the battery
in place.
Fully charge the battery for 15-20 hours.
When charging is complete, pull up on the latch to remove the
battery pack To install the charged battery into the handset,
refer to "Installing the Handset Battery Pack," page 15.
A
In the event of a power failure your spare battery pack
can be used as a back-up power supply for the base unit
16
battery indicator
M
Low
The low battery indicator shows when
the battery needs to be re-charged. If
the phone is not in use, the talk/batt
low LED flashes every three seconds. If
the phone is in use, the talk/batt low
LED flashes every three seconds and
the handset beeps. Complete your
conversation as quickly as possible and
return the handset to the base for
charging.
To maintain a good charge, clean all charging contacts on the handset
and base about once a month with a pencil eraser or other contact
cleaner. DO NOT use liquids or solvents; you may damage your phone.
To locate the handset (while it's
off the base), press page on the
base. The handset beeps for
about 15 seconds.
17
Advertisement
Table of Contents
