Low Battery Indicator - Uniden EXP 9200 User Manual

Charging Optional Extra Battery Packs
You can obtain an optional extra Battery Pack from your Uniden dealer.
The Base Unit of your EXP 9200 is equipped with a Spare Battery Charger for
charging an optional extra Battery Pack.
1. Press the door to open the
Spare Battery Charger.
2. Slide in the
Nickel-Cadmium Battery
Pack so it rests on top of
the ribbon.
Note: The Battery Pack is
keyed to fit so the
electrical contacts
touch the Spare
Battery Charger's
electrical contacts.
The BATTERY CHARGE LED
should light. If the BATTERY
CHARGE LED does not
light, check to see that the
AC Adapter is plugged in, and that the Battery Pack is properly inserted.
3. Press the door to close the compartment.
Note: Allow the Battery Pack to charge without interruption for 12-16
hours. When charging is complete, use the ribbon to remove the
Battery Pack from the Spare Battery Charger.
Base Unit Battery Back-Up Feature
If AC power to the Base Unit fails, and the Spare Battery Charger contains a
battery, the Base Unit will keep operating from the spare battery. This feature
prevents the system from going dead during a power outage.

Low Battery Indicator

When the Battery Pack in the Handset is very low and needs to be charged, the
TALK LED flashes every 3 seconds. If this occurs while you are on the phone, a
short alert beep will also sound. When this happens:
1. Complete your call as quickly as possible. Once the battery is low, you will
only be able to press the TALK button, returning the phone to Standby.
2. Return the Handset to the Base Unit for charging. Allow 12 to 16 hours
without interruption for the Battery Pack to fully recharge. Or, replace the
Handset's Battery Pack with a charged Battery Pack.
13