Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Uniden DG900 DGMax
Summary of Contents for Uniden DG900 DGMax
- Page 3 Warning! Uniden Australia Pty. Ltd DOES NOT represent this unit to be waterproof. Read and understand all instructions: To reduce the risk of fire, electrical shock or damage to the unit, DO Follow all warnings and instructions marked on the product.
- Page 4 12. Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: Unplug all electrical appliances when you know an electrical storm is When the power supply cord is damaged or frayed. approaching. Lightning can pass through your household wiring and If liquid has been spilled into the product.
- Page 5 your home to see what appliances may be causing the problem. In addition, we recommend that the base not be plugged into a circuit that also powers a major appliance because of the potential for interference. Be certain that the antenna on the unit is raised vertically.
- Page 6 Use only the Uniden AC Adapter supplied with this phone. AAD 650U Approval Number N14700 Output: 9V 350mA Input: 230~240V AC 50Hz...
-
Page 7: Standard Wall Plate Mounting
Put the AC adapter cord inside the ) Attach the desktop stand to the base. molded wiring channel, then wrap it around the strain relief notch. Plug the AC adapter into a standard Before you plug the other 240V AC wall outlet. end of the telephone cord into the modular jack on Before using your phone,... -
Page 8: Direct Wall Mounting
2) Remove the wall mount adapter 8) Flip the retainer from front to back, from the notches at the top of then slide it into the slot so that the the base. lip of the retainer faces up and the oval is at the bottom of the retainer. - Page 9 2) Install the nickel-cadmium battery Use only Uniden battery with the label facing down. model BT-900 supplied Line up the mounting slots on the base with your phone.
-
Page 10: Low Battery Indicator
The base unit of your phone is equipped with a compartment for charging an extra battery pack for use in your handset. You can obtain an extra battery pack from your authorized Uniden dealer. To maintain a good charge, clean all charging contacts on the handset 1) Position the battery pack so the inner side with contacts is facing up. - Page 11 Be sure the PULSE/TONE switch is in To attach the beltclip the TONE position unless your local Remove the slot cover. phone system uses pulse dialing Most phone systems use tone dialing. Check with your local phone company if you’re not sure whether your system is tone or pulse.
- Page 12 Your phone may be used with optional headset, the Uniden HS or Uniden 910, Use only the Uniden HS910 CTA 630 or CTA630 headset. To use this feature, simply insert the headset plug into the headset jack. Your headset is ready for hands-free conversations.
-
Page 13: One-Touch Memory Dialing
Press the vol or v key on the handset to increase or decrease On certain occasions after dialing a number, you may be requested to volume while on a call. Volume will remain on the same setting when enter an access code, such as your account number. You can enter this you hang up. - Page 14 Check both ends of the base telephone line cord. Make sure the AC adapter is The DG900 DGMax telephone may work with a 2-wire Analogue PABX plugged into the base and network. However, with the DG900 hook-flash timing fixed at wall outlet.
- Page 15 PROBLEM SUGGESTION The handset doesn’t ring or The Nickel-Cadmium battery pack The DG900 DGMax complies with TS001, TSO02, TSO04, AS/NZ3260 and receive a page. may be weak. Charge the battery 15-20 FCC Parts 15 and 68 (as per ACA Radio Communications Class Licensing on the base unit for hours.