PL1IRR Remote Control
WIRELESS DMX RECEIVER INSTALLATION
Installing Receiver on PL1 LED Luminaires
To install on a PL1 LED Luminaire:
WARNING! Before proceeding, remove power from PL1 LED luminaire.
Step 1. Unpack unit and make sure all parts are present.
Step 2. If antenna is not installed, install antenna.
CAUTION: In next step, do not twist ribbon cable. The RED stripe on ribbon cable should be on same side as RJ45
port on luminaire.
Step 3. A rear of receiver, connect 20-pin ribbon cable (provided with unit) to 20-pin female header connector on
unit.
Step 4. Position unit over luminaire mounting point as shown in Figure 2. Make sure ribbon cable is completely
encased in receiver housing before securing to luminaire. Do not pinch ribbon cable.
Wireless DMX Receiver
M4 x 30 mm SCHS
Screws (x2)
Note A: Make sure the red stripe is towards the luminaire's
RJ45 (DMX512) port when connecting ribbon cable to fixture.
Step 5. Install receiver unit by inserting two M4 X 30 mm socket cap head screws (provided with unit) through
holes in receiver housing into luminaire. Hand-tighten screws using a 3 mm Allen Wrench (not provided) or
ARLAKTOOL (provided with PL1 LED luminaires). Do not over tighten!
Step 6. Once installation is complete, proceed to
configuration instructions.
20-Pin Female
Connector
20-Pin Interconnection
Ribbon Cable
(See Note A)
Figure 2: Wireless DMX Receiver Installation - PL1 LED Luminaires
PL1 LED Luminaire
"WIRELESS DMX RECEIVER OPERATION" on page 7
User's Guide
for
5