PL1IRR Remote Control
WIRELESS DMX RECEIVER OPERATION
Configuring the Luminaire to Operate with Receiver
To enable wireless DMX communications:
Step 1. Install unit according to instructions contained in
page
Step 2. Power on luminaire.
Step 3. At luminaire display, enable luminaire to operate with wireless DMX receiver as follows:
a. Press
b. Scroll to
c. At
d. Press
Step 4. Receiver is ready to connect to a wireless DMX transmitter. Refer to transmitter manual for signal
assigning/connecting to transmitter and DMX512 signal set up.
Unlinking Receiver from Connected Transmitter
To unlink (disconnect) receiver from its connected transmitter:
Step 1. At luminaire display, change luminaire DMX Address to
Step 2. The luminaire LCD display will show a message saying,
Step 3. The luminaire DMX address will return to its previously set DMX address when unlinking is completed.
Luminaire LCD Display Icons and Meanings
LCD Display Icon
Note: The RJ45 port on the receiver is DMX512 output only. The port uses a RJ45 to DMX512 cable available from
Philips Selecon. Contact your local Philips Selecon dealer or Philips Selecon for more information.
5.
button and arrows on luminaire menu until
[Menu]
DMX
section.
DMX
DMX Enabled
section, select
button to reboot.
[ESC]
Icon Name
Signal Linked
Signal Linking
(or Seeking Lost Signal)
"WIRELESS DMX RECEIVER INSTALLATION" on
Settings
No
- options are
000
.
Un-Linking
Description / Meaning
Receiver is not assigned or connected to a wireless
Unlink
DMX512 transmitter
Receiver is assigned and connected to a wireless
DMX512 transmitter BUT DMX512 signal is not
Linked
present. Note, the luminaire LCD display will be
NORMAL in appearance.
Receiver is assigned and connected to a wireless
DMX512 transmitter AND DMX512 signal is present.
Note, the luminaire LCD display will be REVERSE in
appearance.
Receiver is process of linking to transmitter or;
Signal link to transmitter is lost and trying to
reacquire signal.
screen appears. Press
Yes
Wireless
,
, or
. Select
for about 5 seconds.
User's Guide
button.
[Enter]
Wireless
.
7