Table of Contents
Advertisement
SPECIFICATIONS
CD
S/N Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 70dB
Sampling Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44.1Khz
Quantization Bits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 bit
Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-20,000Hz
FM Radio
Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87.5-107.9MHz
Usable Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 15dB at S/N 30dB
Stereo Separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25dB at 1KHz
S/N Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50dB
AM/MW
Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 530-1710KHz
Usable Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . > 45dB
S/N Ratio. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40dB
General
Operating Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . DC 11 -14.4V
Grounding System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Negative Ground
Speaker Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ohms
Power Output . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40W x 4
TROUBLESHOOTING
Symptom
No power
The vehicle's power is not
on
The fuse is blown
Disc cannot be loaded or
Presence of CD disc inside
ejected
the player
Inserting the disc upside
down
Compact disc is extremely
dirty or disc is defective
Temperature inside the
vehicle is too high
Condensation
No sound
Volume too low or Mute is
on
Fader is set incorrectly
Wiring is not properly con-
nected
Unit is unresponsive
The built-in microcomputer
is not operating properly
Sound skips
The installation angle is
more than 30 degrees
The disc is dirty or defective Clean the disc and try to play
Cannot tune to radio sta-
The antenna cable is not
tion, auto-seek does not
connected
work
The signals are too weak
ERROR 1
Mechanism Error
ERROR 2
Servo Error
8
JCDWIN
Cause
Solution
If the power supply is properly
connected to the vehicle acces-
sory terminal, switch the ignition
key to "ACC".
Replace the fuse.
Remove the disc in the player and
insert the new one.
Insert the compact disc with the
label facing upward.
Clean the disc or try to play a new
one.
Wait until the ambient tempera-
ture returns to normal.
Leave the player off for an hour or
so, then try again.
Adjust volume to audible level.
Press AUDIO button to access
menu and adjust FADER setting/
Check wiring connections.
Press the RESET button.
Adjust the installation angle to
less than 30 degrees.
again or use new disc.
Insert the antenna cable firmly.
Select a station manually.
Press the eject button to correct
the problem.
If the error code does not disap-
pear, consult your nearest ser-
vice dealer.
Press the eject button to correct
the problem.
If the error code does not disap-
pear, consult your nearest ser-
vice dealer.
Advertisement
Table of Contents
