GE JB450GP Use And Care & Installation Manual page 26

Cooktop Surface Lamp
( equipped)
models so
on
WHEN CHANGING A
COOKTOP LAMP, DO NOT
TOUCH THE METAL AT
ENDS OF LAMP.
Your cooktop light is easily replaced
with a fluorescent tube of the same
wattage. Make sure the power to
the range is disconnected at main
bottom edge toward you and then up.
PI ace fingers on top near each
Roll top of bulb gently toward
front of range and gently pull the
it does not hit the lamp cover.
To replace:
PI ace fi n:ers on top near each
end of ] ight bu]b.
Press bulb into s]ots until it snaps
into place.
Move 1 amp cover down and snap
into place.
Surface Units
pan/rings often. Built-up soil,
especially grease, may catch fire.
To make cleaning easier, tilt-lock
units lift
position, and plug-in units
are removable.
Caution: Be sure all controls are
turned to OFF and surface units
are cool before attempting to lift
or remove them.
removing a plug-in unit, remove
the drip pan/rings and clean them
according to directions in the
Cleaning Guide. Wipe around the
Rinse all washed areas with
a damp cloth or sponge.
26
Tilt-Lock Unit
(on models so equipped)
Tilt-lock units cannot be removed.
You can lift a tilt-lock unit upward
about 6 inches and it will lock in
the up position.
To reposition the tilt-lock unit:
Replace the drip pan into the
recess in the cooktop.
If you have a separate trim ring, put
it in place over the drip pan. The drip
pan must be under the trim ring.
Guide the surface unit into place
so it rests evenly.
Plug-In Units
(on
models so equipped)
Plug-in units can be removed.
Lift a plug-in unit about 1 inch
above the trim ring—just enough
to grasp it—and pull it out.
Do not lift a plug-in unit more
than 1 inch. If you do, it may not
lie flat on the trim ring when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1 inch above the
trim ring can permanently
damage the receptacle.
Separat
Rece
R
To replace a plug-in unit:
Replace the drip pan into the
recess in the cooktop. Make sure
opening in pan lines up with
receptacle. If you have a separate
trim ring, put it in place over the
drip pan. The drip pan must be
under the trim ring.
Insert the terminals of the plug-in
unit through the opening in the drip
pan and into the receptacle.
Guide the surface unit into place
so it rests evenly.
CAUTION
Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
. Do not bend the plug-in surface
unit plug terminals.
Do not attempt to clean, adjust
or in any way repair the plug-in
receptacle.