GE JB450GP Use And Care & Installation Manual page 30

BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT: Save these instructions for the
local electrical inspector's use.
IMPORTANT: OBSERVE ALL GOVERNING
CODES AND ORDINANCES.
NOTE TO INSTALLER: Leave these
instructions with the appliance after installation
is completed.
NOTE TO CONSUMER: Keep this Use and
Care Guide and Installation Instructions for
future use.
NOTE: This appliance must be properly grounded.
TOOLS YOU WILL NEED
Large blade screwdriver
Channel lock pliers
ELECTRICAL REQUIREMENTS
CAUTION, FOR PERSONAL SAFETY:
DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.
REMOVE HOUSE FUSE OR OPEN CIRCUIT
BREAKER BEFORE BEGINNING
INSTALLATION.
This appliance must be supplied with the proper
voltage and frequency, and connected to an
individual, properly grounded branch circuit,
protected by a circuit breaker or time delay fuse, as
noted on the rating plate.
Wiring must conform to National Electric Codes.
If the electric service provided does not meet the
above specifications, it is recommended that a
licensed electrician install an approved outlet.
Because range terminals are not accessible after
range is in position, flexible service conduit or cord
must be used.
STEP 1
adjacent vertical walls above cooktop surface.
Allow 30" minimum clearance between surface
units and bottom of unprotected wood or metal
top cabinet, and 15" minimum between
countertop and adjacent cabinet bottom.
STEP 1
(cont.)
eliminate the risk of burns or fire by reaching
To
over heated surface units, cabinet storage space
above the surface units should be avoided. If
cabinet storage is to be provided, the risk can be
reduced by installing a range hood that projects
horizontally a min. of 5'1 beyond the bottom of the
cabinets.
NOT LESS THAN
WIDTH OF RANGE
1,
30"
MIN.
15"
MIN.
MIN.
OUTLET BOX
INSTALLED
either
LOCATE OUTLET
/ BOX WITHIN
SHADED AREA
I
rear