Table of Contents
Advertisement
Finisher Tests
Staple Test
This test verifies the operation of the staple mechanism in the finisher.
To run the Staple Test:
1.
2.
The printer feeds eight pieces of media to the finisher and accumulates all eight pieces in
the accumulator. After the last sheet is accumulated, the pack is stapled.
3.
Finisher Feed Test
This test verifies that media can be fed to a Finisher output bin and then stapled.
To run the Finisher Feed Test:
1.
2.
The printer feeds eight pieces of media to the selected finisher output bin where they are
stapled.
Note: No information is printed on the fed sheets as the laser is not engaged during this
test.
3.
Finisher Sensor Test
This test determines if the Finisher sensors are working correctly.
To run the Finisher Sensor Test, select Finisher Sensor Test from the Finisher Test menu.
If you Select Media 1 from the menu the following will be displayed and the sensors
polled:
Media Path 1
testing............
3-18
Service Manual
Select Staple Test from the test menu.
Select a destination bin.
When the test is complete, the printer returns to the original screen.
Select Finisher Feed Test from the menu.
Select a destination bin.
This test cannot be canceled or terminated once the test has begun. When the test
is complete the printer returns to the original screen.
5060-XXX
Advertisement
Table of Contents
