Char-Broil 463261508 Product Manual page 19

Under sideburner shelf, attach sideburner ignitor wire to electrode (A).
11
Place burner cap onto sideburner (B).
Attach sideburner cap clip ( C ).
Place sideburner cooking grate onto sideburner shelf, aligning grate legs with holes in shelf (B).
Sideburner Ignitor Wire
C
Sideburner
cap clip
attach tank heat shield and shield extension together with (2) #8-32x3/8" screws, 4mm flat washers, 4mm lock washers and
12
#8-32 hex nuts. Inside of cart, insert rear shield tabs into two left slots between upper and lower back panels. Attach left and
center front shield tabs under front brace with (2)
beneath grease tray opening in upper back panel.Attach left rail to brace, with (1) #8x3/8" self-tapping screw. Attach right rail
and right front shield extension tab together under front brace with (1) #8x3/8" self-tapping screw.
Tank heat shield extension
Tank heat shield
A
Sideburner cooking grate
Burner cap
Grease tray opening
Self-Tap Screw
Some components not
shown for illustration
purposes.
B
#8x3/8"
self-tapping screws. Insert left and right grease tray rails into slots
4mm Flat Washer
#8x3/8"
Qty. 2
Stainless Screw
Qty. 2
#8x3/8"
Qty. 4
#8-32 Hex Nut
4mm Lock Washer
Qty. 2
Front brace
Left grease tray rail
Right grease tray rail
Qty. 2
463261508 • 19