Introduction
1. Front View
1). (IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby)LED Indicator: Press POWER to turn on and off.
Indicator on(Red)
Indicator on(Green)
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
window.
2). The functions of the buttons:
INPUT: Press to display the input source menu.
MENU: Press to display the OSD menu,
press again to exit the menu.
CH+/-: Press to scan through channels.
VOL+/-: Press to adjust the volume.
POWER: Turn on/standby the TV set.
Introduction
Remote Control window
(Keep clear)
Standby mode
Power on mode
0
to the left or right side and 20
Press INPUT button on the TV set or the SOURCE button
on the remote control to
and use
remote control to select the
on the remote control to
Note: Before you select the input source, make sure the
connections are prepared.
Led Indicator
0
above or below the remote control
display the input source menu,
CH+/- button on
the TV set or
input source, press OK button
enter.
5
/
button on