Connecting Wires To - Kenwood KIV-700 Instruction Manual

Connecting Wires to Terminals
Do not remove the cap when you do not use
⁄
USB device
the USB cable. The connector will cause the
(commercially
unit to malfunction if it gets in touch with any
available)
metallic part of the vehicle.
iPod
(commercially
available)
iPod
AUDIO OUT
iPod
VIDEO OUT
iPod cable
(Accessory 4)
Power control/Motor antenna
control wire (Blue/White)
8 6 4
7 5 3
8 6 4
7 5 3
68
|
KIV-700
Parking sensor wire (Light Green)
USB connector (1m)
Fuse (10A)
Wiring harness
(Accessory 1)
Steering remote control wire
(Light Blue/Yellow)
Mute control wire (Brown)
Battery wire (Yellow)
Ignition wire (Red)
See next page
⁄
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
2
1
2
Connector B
1
Autogood products Internet store "130"
For the sake of safety, be sure to connect
the parking sensor.
⁄
Parking sensor wire Junction cable
(Light Green) (Accessory 3)
iPod audio output (Left: White, Right: Red)
iPod visual output (Yellow)
R
FM/AM antenna input (JASO)
R L
AUX input (Stereo)
Use the mini-plug (3.5 mm ø) which
is stereo type and does not have any
resistance.
To Kenwood disc changer/External optional accessory
To connect these leads, refer to the relevant instruction
⁄
manuals.
To use the steering wheel remote control feature,
REMOTE CONT.
you need to an exclusive remote adapter (not
supplied) matches your car is required.
STEERING WHEEL
REMOTE INPUT
Connect to the terminal that is grounded when
MUTE
either the telephone rings or during conversation.
To connect the Kenwood navigation system,
⁄
consult your navigation manual.
Connect either to the power control terminal
P.CONT
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
ANT.CONT
If no connections are made, do not
let the wire come out from the tab.
Connect to the vehicle's parking
brake detection switch harness.
L
Rear output
Front output
Sub Woofer output
Antenna Cord