Belts And Pulleys - MULTIQUIP Diamond Back SP303516 Street Pro Operation And Parts Manual

Belts and Pulleys

Belt
Spindle Drive Belt (POWERBAND)
Transaxle Drive Belt
Engine to Jack shaft Drive Belt
Spindle
(Blade Shaft)
Drive Belt
V-Belt Tension
The ideal V-Belt tension is the lowest tension at which the belt will not slip under peak load
conditions. Check V-Belt tension frequently during the first 24-48 hours of run-in operation.

 Keep belts clean of foreign material that may cause slippage.
 Make V-Belt inspection a periodic procedure.
CAUTION
 Never dress belts, as this causes premature failure.
MQ SP-3035 CONCRETE SAW — OPERATION AND PARTS MANUAL — REV. #3 (09/29/06) — PAGE 41
Qty Part Number
1 520006
1 521005
1 521005
Fig. 27 — Belt Locations
Over-tensioning shortens belt and bearing life.
MQ SP-3035 CONCRETE SAW
TransAxle Drive Belt
Engine
Jack
Drive Belt
to
Shaft