Table of Contents
Advertisement
If you experience difficulties in the use of this music system, please check the followings or call at
1-800-777-5331 for Customer Service and Support.
Symptom
Radio
Noise or sound distorted
on AM or FM broadcasts.
FM STEREO does not
appear on display.
AM or FM, no sound.
Compact Disc Player
CD Player will not play.
CD skips while playing.
Function inoperative and
jammed
Display no indication or
abnormal indication
Intermittent sound
No sound when played in
the AUX Mode
TROUBLESHOOTING GUIDE
Possible Cause
Station not tuned properly for AM or
FM
FM: Wire antenna is not extended.
AM: The bar antenna is not
positioned correctly.
You have tuned to a mono station or
the station too weak.
Unit not at Tuner function, AM or FM
band.
Volume at minimum.
Unit not in CD function mode.
CD is not installed incorrectly.
Disc is dirty or scratched.
Built-in microcomputer needs to be
reset.
Built-in microcomputer needs to be
reset.
Dirty or defective disc
Dirty Pick Up lens
Player is subject to excessive shock
or vibration
Power to external source ( MP3, VCR
etc) not switched on
Connection to external source (MP3,
VCR etc) is incorrect: e.g. RCA plug
may have been inserted to AUDIO IN
of the external source.
Master Volume is at minimum.
Retune the AM or FM broadcast
station.
Extend the FM Wire antenna.
Reposition the unit until the best
reception is obtained.
Select another FM station.
Press Function button to select AM or
FM.
Increase Volume.
Press Function button to select CD1
or CD2.
Insert CD with label facing frontward.
Wipe disc with cloth or use another
disc.
Disconnect and reconnect the power
cord after a few minutes.
Disconnect and reconnect the power
cord after a few minutes.
Clean or replace the defective
disc
Use a CD-lens cleaning disc to clean
the lens
Relocate the player away from shock
or vibration
Switch on the power of the external
source.
Reconnect the RCA Plug to the
AUDIO OUT of the external source.
Adjust the master volume
14
Solution
Advertisement
Table of Contents
