Wiring - Jensen VM8022 Installation And Operation Manual

VM8022

WIRING

NOTE: The amplifier in this
radio is only designed for use with
four speakers. Never combine
(bridge) outputs for use with two
speakers. Never ground negative
speaker leads to chassis ground.
Failure to wire exactly as shown
may cause electrical damage to the
radio.
NOTE: Only connect speakers with
a nominal impedance of 4 ohms.
Speakers with a load
impedance less than 4 ohms
could damage the unit.
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
Yellow
FRONT SP
White/Black White Gray/Black Gray
Stripe Stripe
Left Speaker Right Speaker
(Front) (Front)
Parking
Fuse (15A)
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Blue
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Red
REAR SP
Green/Black Green Purple/Black Purple
Stripe Stripe
Left Speaker Right Speaker
(Rear) (Rear)
3
(Blue)
(Yellow)
(Yellow)
A/V Media
Adapter Cable
IMPORTANT!
The pink parking wire MUST
be connected to the switched
side of the parking break
circuit (the part that becomes
grounded when the brake is
applied).