Two Vcrs For Tape Editing - Sony KDL-V26XBR1 Operating Instructions Manual

Connecting the TV
Two VCRs for Tape
Editing
Using
S VIDEO jacks?
See page 20.
Cables are often
color-coded to connectors.
Connect red to red,
white to white, etc.
VCR (playback)
36
If you connect two VCRs, you can record from one VCR to the other while
using your TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1
Use A/V cables to connect the playback VCR's A/V output jacks to the
recording VCR's A/V input jacks.
2
Use A/V cables to connect the recording VCR's A/V output jacks to the
TV's A/V input jacks.
A/V cable
To perform tape editing, set the TV to the video input intended for
playback by pressing TV/VIDEO on the remote control.
You may need to change the video input on your VCR. Consult
your VCR's operating manual for instructions.
If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the video cable (yellow) on your
combined A/V cable.
Use an S VIDEO cable to connect the playback VCR's S VIDEO OUT
jack to the recording VCR's S VIDEO IN jack. S VIDEO does not
provide audio, so audio cables must be connected to provide
sound.
You cannot record signals from equipment connected to the
Y P /C P /C
B B R
VCR (recording)
AUDIO-R
AUDIO-L
A/V cable
input.
R
Rear of TV
1 3
S VIDEO
VIDEO
L
(MONO)
AUDIO
R
VIDEO IN
VIDEO