Kit Installation - Jensen MP6212 Instruction Manual

Mobile receiver

Hide thumbs

Table Of Contents

Table of Contents

MP6212

Using the Mounting Sleeve

Slide the mounting sleeve off the chassis. If it is locked into position,

use the removal tools (supplied) to disengage it.

Check the dashboard opening size by sliding the mounting sleeve into

it.

If the opening is too small, carefully cut or file as necessary until the

sleeve easily slides into the opening. Do not force the sleeve into the

opening or cause it to bend or bow. Check for sufficient space behind

the dashboard for the radio chassis.

Locate the series of bend tabs along the top, bottom, and sides of the

mounting sleeve. With the sleeve fully inserted into the dashboard

opening, bend as many of the tabs outward as necessary to firmly

secure the sleeve to the dashboard.

CAUTION: For proper operation of the CD player, the chassis must be

mounted within 20° of horizontal. Make sure the unit is mounted within

this limitation.

Place the radio in front of the dashboard opening so the wiring can be

brought through the mounting sleeve. Follow the wiring diagram

carefully and make certain all connections are secure and insulated

with wire nuts or electrical tape. See "Wiring" on page 5. After

completing the wiring connections, turn the unit on to confirm operation

(vehicle ignition must be on). If the unit does not operate, re-check all

wiring until the problem is corrected.

Make sure the radio is right-side up, then

carefully slide the radio into the mounting

sleeve until it is fully seated and the spring clips

lock it into place.

Secure the rear of the unit to the car body

using the mounting bolt and rubber cushion.

Test the radio using the Operating Instructions

that follow.