Heading Mode (Hdg) - Garmin G300 Pilot's Manual

integrated autopilot
Initial Bank Angle
Less than 6°
6° to Maximum Bank Setting
Greater than Maximum Bank Setting Limits bank angle to maximum bank setting
CHANGING THE ROLL REFERENCE
To adjust the roll reference while in Roll Hold Mode, hold the CWS
Button, establish the desired bank angle, then release the CWS Button.

heading mOde (hdg)

Heading Mode is activated by pressing the AP HDG Softkey. Heading
Mode acquires and maintains the Selected Heading. The Selected Heading
is shown by a light blue bug on the HSI and Heading Tape and in the box
to the upper left of the HSI.
CHANGING THE SELECTED HEADING
nOte: Press and hold the FMS Joystick (on the PFD or PFD Page) to
synchronize the Selected Heading to the current heading.
Changing the selected heading (integrated autopilot config-
ured):
1) From the PFD Page (one display) or PFD (two display), press the HDG/
ROLL Softkey (if necessary). The Heading Box is highlighted.
2) Turn the FMS Joystick to select the desired heading, and press the ENT
Key. The Selected Heading is shown to the left of the HSI.
Holding the CWS Button and hand-flying the aircraft does not change
the Selected Heading. The Integrated Autopilot guides the aircraft back to
the Selected Heading upon release of the CWS Button.
198
Rolls wings level
Maintains current aircraft bank angle
Roll Hold Mode Responses
Heading Mode Annunciation
Garmin G300 Pilot's Guide
Autopilot Roll Reference
190-00921-00 Rev. D