Wiring Diagram - Jensen CD6112 Instruction Manual

WIRING DIAGRAM

Antenna
Connect the antenna plug
from the existing antenna
cable (some vehicles
require an adaptor).
R (Red)
L (White)
Connect to ground terminal
or clean, unpainted part
of chassis.
Memory/Battery
Connect to battery or 12 volt
power source that is always live.
The radio will not work if this
wire is not connected.
White/Black
NOTE: The amplifier in this radio is only designed for use with four
speakers. Never combine (bridge) outputs for use with two speakers.
Never ground negative speaker leads to chassis ground. Failure to
wire exactly as shown may cause electrical damage to the radio.
Aux-in
Ground
Black
Yellow
FRONT SP
White Gray/Black Gray
Stripe Stripe
Left Speaker Right Speaker
(Front) (Front)
Fuse (15 amp fast blow ATO)
Rear Line out
Gray
Blue
Red
REAR SP
Green/Black Green Purple/Black
Stripe Stripe
Right Speaker
Left Speaker
(Rear) (Rear)
NOTE: Only connect speakers rated in the load impedance of 4 ohms.
Speakers with a load impedance less than 4 ohms could damage the
unit.
4
CD6112
R (Red)
L (White)
Power Antenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Purple