Setting The Internal Buzzer (For Model With An Internal Buzzer)65 - Epson TM-T88V Technical Reference Manual

Setting the Internal Buzzer
(for Model with an Internal Buzzer)
When using the internal buzzer, configure the buzzer.
Models with the buzzer function can beep the buzzer when the drawer is opened.
The buzzer setting is performed by setting the DIP switches for the buzzer and specifying
connector pin numbers to which a command outputs a pulse signal.
DIP
Specified connector pin
switch
1 Drawer kick out connector pin 2
2 Drawer kick out connector pin 5
Since the buzzer drive signal and the cash drawer drive signal are common in the printer,
do not use the same connector pin numbers to output the signal for the buzzer and the
cash drawer.
For detailed information about ESC/POS commands, see the ESC/POS Application
Programming Guide.
ON OFF
Buzzer does not
Buzzer beeps.
beep.
Buzzer does not
Buzzer beeps.
beep.
Chapter 2 Setup
Initial setting
ON
OFF
2
65