Epson TM-T88V Technical Reference Manual page 41

DIP Switch Bank 2
SW Function
2-1 Handshaking (BUSY condition)
R e s e r v e d ( D o n o t c h a n g e
2-2
setting)
2-3 ∼
Selects print density
2-4
Sets the release condition of the
receive buffer BUSY state. (This
2-5
function is effective when DIP
Switch 1-2 is set to off.)
R e s e r v e d ( D o n o t c h a n g e
2-6
setting)
2-7 I/F pin 6 reset signal
2-8 IF pin 25 reset signal
• For DIP Switch 2-1 (BUSY condition), see also
• Do not change the setting of DIP switches 2-2 and 2-6. Otherwise, the printer may not
operate normally.
ON
• Offline
Receive buffer full
• Receive buffer full
Fixed to OFF
See "Selecting the Print Density (DIP Switches
2-3/2-4)" on page 45.
Releas es the BUSY R e l e a s e s t h e B US Y
s t a t e w h e n t h e s t a t e
remaining capacity remaining capacity
of the receive buffer of the receive buffer
reaches 138 bytes. reaches 256 bytes.
Fixed to OFF
Enabled
Enabled
"Selecting the BUSY Status" on page
Chapter 2 Setup
Initial
OFF
setting
OFF
OFF
OFF
w h e n t h e
OFF
OFF
Disabled OFF
Disabled OFF
46.
41
2