Moving About - Mercury Owner's Manual

7.6 MOVING ABOUT

♦ Switch off the power with the ignition key before moving. Always dismount from the scooter before
moving.
♦ Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could cause
damage or injury.
♦ For your safety, always ask for help if required. You will need two people when moving or lifting the
scooter whole. If you are on your own, please disassemble the scooter before lifting. Refer to the section
below.
7.7 DISASSEMBLING THE SCOOTER
Both the models of scooter can be disassembled in to four pieces. These are the seat (weight 6kg), the front
section (Prism 3-wheel front section weight 14.6kg, Prism 4-wheel front section weight 19.1kg), the rear
section (weight 10.6kg), and battery pack (weight 9.8kg) without any tools.
The procedure for disassembly is the same for both scooters. Please follow the steps and photographs below:
1. Push the Seat Rotate Lever
whilst pulling up on the seat to
remove.
4. Lock the front wheel and tiller
by pulling the wheel lock catch
down.
Mercury Prism Electric Scooter
2. Lift out the battery pack from
the main body of the scooter.
5. Pull up the scooter using the
seat post, whilst pulling the red
handle behind the seat post.
Page 20 of 28
3. Loosen the tiller adjustment
knob and fold down the tiller and
retighten knob.
6. Lift the front section up until
the lower pegs are longer in
contact with the curved locking
brackets on the rear section.
Owner's Handbook (Part Code: Z40949)