Kodak Prosper S10 Operator's Manual page 22

Chapter 2. Printer Operation
Fluid Container Replacement
Figure 12 Waste container, quick disconnect/cap
Quick
disconnect
Waste line
Cap
Bung/float
Electrical connector
Kodak Prosper
22 S10 Printer
5. For transport, plug both holes with the original bungs so that the
waste fluids do not spill.
6. Discard the fluids in the full waste container. Follow all applicable
regulations to discard waste fluids.
7. Install the gray cap on the empty waste container (Figure 12).
8. Push and hold the quick-disconnect buttons and then push the waste
lines onto the gray cap until they click (Figure 12).
9. Install the bung/float on the empty waste container (Figure 13).
10. Connect the electrical connector (Figure 13).
After the waste container is replaced, the "EXTERNAL WASTE FULL"
message will automatically be acknowledged and go away.
Figure 13 Waste container, cap/float
Waste line