Advertisement
15. Pry out the two screw hole plug buttons on the bottom left side of the top door and
lower door. On some models, remove the door stops (metal plates) on the bottom
of eachdoor and install them on opposite sides. Press in the plug buttons in the holes
on the right side of both doors.
16. Set thelower door on the bottomhinge, making surethe hinge pinentersthe bushing
in the door bottom.
17. While hoWtirtcj t he doer in a clesed positlen, take the canter hinge pin that was
removed in step 8 and screw it through the left hole of the center hinge and into the
bottom doorbushing. Make surethe long pin goes intothe bottom door and the short
pin goes into the top door.
18. Set the upper door on the center hinge, making sure the hinge pin enters the door
bushing. When you close the door, the gasket should hold it in place.
19. Making sure to use the same number of spacers that were originally used beneath
the upper hinge, install the hinge mountingscrews. Beforetigbteningthesescrews,
make sure the top of the door is level with the cabinet top, and the space between
the door is equidistant across the entire front. Avoid over-tightening these screws.
Tighten both until they are just snug, then turn them in another one-half turn.
20. Examine the door gasket all around each door, making sure no gaps are visible
betweenthegasketandcabinet.
Ifagapshows, trystretchingthegasketaway#om
the door. The magnet will contact the cabinet surface.
21. Insta}]the handles on opposite sides of the doors as shown.
22. To replace the base grille, line up its spring clips with the square openings in the
cabinet and tap each end in until the grille locks in place. Replace hinge cover.
23. Replace all food and return the fresh food control to its usual operating position.
17 j./
"
I
_
J
_ 7
LOWER
.....
UPPER
DOOR
=
DOOR
HANDLE
II
_J
n
Handle
.
I
extension
._,_ /
(some models)
/
I
HANDLE
EXTENSION
I
[IF USED)
Advertisement
