Advertisement
If you are installing your new refrigerator yourself, please follow these helpful sugges-
tions.
1. Remove base skids,
i I-J] L
[-j I
2. Remove all exterior and interior tape carefully and
,, ,_ll
retain old tape. Make a small pad of this tape to pick
off any remainingtape residues. This will eliminate the
need to use dangerous Solvents of any kind.
3. Remove and discard the cantilever shelf packing clips
located just above each shelf where they hook onto
the frame. To remove the red plastic clip, wiggle it
sideways and pull straight out.
4. Select a location for your new refrigerator away from any heat sources. Allow a free
flow of air through the front base grille.
5. Your model should not be installed where the room temperature will go below
55°,=. because Jt will not run frequently enough to maintain proper temperature in
the freezer.
To enhance its appearance, maintain efficient performance and for proper function of
the ice maker, your refrigerator should be level. Using a carpenter's level, check your
refrigerator to make sure it is level front to back and side to side. The front wheels were
adjusted at the factory so the cabinet would be level. However, jarring in transit, or
standing the refrigerator on an uneven floor may cause the cabinet to appear unlevel.
If leveling is necessary, remove the base grille and adjust:
Models JRT199, JRT219, JRTD229
TUaN CLOCKWISE
TO
RAISE CABINET CORNER
TOlock the cabinet in place, turn down one or
I ._.
bothlocking feet, located nearthe front wheels.
r-,
Rear leveler feet are not required.
ifthe floor is notlevel and it is necessary to raise
xt_
the rear of the cabinet, we suggest rolling the
rear wheels on to a piece of plywood or other
TURN COUNTER-CLOCKWISE
shim
material,
To LOWER CABINET CORNER
Advertisement
