Led Work-Light - Bostitch N62FNB Operation And Maintenance Manual

LED WORK-LIGHT

To operate the LED work-light you must first remove an electricity isolated plastic sheet before using the LED
work-light.
1. Pull up the nose cover to open.
2. Pull out the electricity isolated plastic sheet.
3. Close the nose cover.
4. LED light is on/off by pressing light button on the cover.
REMOVE THE LIGHT
LED work-light can be easily removed or if needed.
1. Pull up the nose cover to open
2. Press on the snap-fitting hook to release LED work-light.
3. Take out the LED work-light from the cover.
REPLACE THE LIGHT
Insert a new LED work-light.
1. Align housing of the LED work-light into nose cover until it snaps into position. Make sure the button is placed
through nose cover hole.
2. Pull out the elecricity isolated plastic sheet.
3. Close the nose cover.
-10-