Led Work-Light - Bostitch DA1564K Operation And Maintenance Manual

LED WORK-LIGHT

To operate the LED work-light you must first remove an electricity isolated plastic sheet before using the LED
work-light.
1. Pull up the nose cover to open.
2. Pull out the electricity isolated plastic sheet.
3. Close the nose cover.
4. LED light is on/off by pressing light button on the cover.
REMOVE THE LIGHT
LED work-light can be easily removed or if needed.
1. Pull up the nose cover to open
2. Press on the snap-fitting hook to release LED work-light.
3. Take out the LED work-light from the cover.
REPLACE THE LIGHT
Insert a new LED work-light.
1. Align housing of the LED work-light into nose cover until it snaps into position. Make sure the button is placed
through nose cover hole.
2. Pull out the elecricity isolated plastic sheet.
3. Close the nose cover.
NOTE: The LED worklight and battery is supplied and fitted as a single component and cannot be
serviced. If the LED or battery needs to be replaced, a new unit should be fitted.
• DO NOT dispose of this unit with household waste.
• Always dispose of batteries according to local legislation.
• Please recycle in line with local provisions for the collection and disposal of electrical and
electronic waste.
This component is excluded from any extended warranty and will operate for approx. 100,000 tool cycles.
-10-