Preparing The Headset For Use; Adjusting The Headband; Relocating The Microphone Boom; Sliding Over The Wind Screen - Sennheiser HMD 280 PRO Instructions For Use Manual

Preparing the headset for use

Adjusting the headband

For good transmission quality and best possible comfort,
the headband has to be adjusted to properly fit your head.
To do so, adjust the headband via its snap-in locking
mechanism.

Relocating the microphone boom

The microphone boom can be worn on either side of the
mouth.
Loosen the quick-fixing device.
Turn the microphone boom towards the mouth.
Tighten the quick-fixing device.

Sliding over the wind screen

Before using the headset, slide the wind screen over the
microphone. The wind screen must totally enclose the
microphone.
Important:
Position the microphone towards the corner of
the mouth
The headsets feature a flexible microphone boom.
Bend the microphone boom so that the microphone
is placed at the corner of the mouth. Maintain a
distance of approx. 2 cm between microphone and
mouth. In this position, the risk of pop noise is
reduced to a minimum.

Mounting a connector

To mate with any signal jack the headset's connecting cable
can be fitted with a connector of your choice
(u "Connection diagrams").
20

Folding up the headset

For space-saving transportation, the headset can be folded
up in two different ways:
1. To fold up the headset as compact as possible, tuck the
earcup without microphone boom inside the headband.
Then fold the earcup with the microphone boom
against the headband.
2. To fold up the headset as flat as possible, the earcups
can be rotated by 90°. Press the microphone with the
flexible microphone boom as far as possible against
the earcups.

Cleaning the headset

To clean the headset, use a soft, damp cloth. If necessary,
the headset can be cleaned with soapy water (use a mild
cleanser such as washing-up liquid).
Note:
Never use solvent-containing cleansers.
21