Table of Contents
Advertisement
Making calls using the headset
Adding a GUEST headset to a conference call
Press and hold the Audio button while placing the guest headset into
the base station of the master headset.
The Headset LED alternately flashes blue/red until a link to the base
station is established. The Headset LED flashes blue 3 times.
Take the guest headset out of the base station. You hear a beep in the
master headset.
To add the guest headset to the conference call, press the Link button
on the master headset within 15 seconds.
Repeat this procedure to add additional guest headsets to the
conference call.
GUEST 1-3
or
MASTER
Call the other party.
The Link LED
on the base station flashes blue.
Dropping a GUEST headset from the conference call
Press the Link button on the guest headset. The guest headset is
dropped from the conference call.
"easy pairing"
To subsequently use the guest headset with other base stations,
place the guest headsets into the other base stations. The
Headset LED alternately flashes blue/red until a link is established.
Ending a conference call
Place the master headset into the magnetic holder of the base station
to end the conference call and to drop the guest headsets from the
3x
on
conference call.
28 |
SD Series - User Guide
SD Office – HS
Press & hold the mute button
& insert the headset
into the charging
cradle.
SD Pro1 – HS
SD Pro2 – HS
3x
Accept the
GUEST headset.
Charging the headset and storing the headset system
Charging the headset and storing the
headset system
Charging the headset
Always store the headset in the base station to ensure that it is fully
charged when needed. The intelligent battery charging technology pre-
vents over-charging.
SD Office – HS
Place the headset into the magnetic holder of the base station.
The Headset LED lights up blue and the rechargeable battery is being
charged. The Charge status LED on the base station indicates the
charge status:
LED segment
(white = lit up)
Shortly before the rechargeable battery is about to run flat, only one LED
segment lights up weakly. The Headset LED flashes red and you hear three
beeps. You have several minutes of battery reserve. When the recharge-
able battery is flat, the headset switches off.
25% 50%
75%
100%
SD Pro1 – HS
SD Pro2 – HS
Corresponds to a talk time of
Required
charging time
Wideband
Narrowband
approx. 10 min.
approx. 2 hrs
approx. 3 hrs
approx. 20 min.
approx. 4 hrs
approx. 6 hrs
approx. 40 min.
approx. 6 hrs
approx. 9 hrs
approx. 60 min.
approx. 8 hrs
approx. 12 hrs
SD Series - User Guide
| 29
Advertisement
Table of Contents
