Procedure 2.2 - Running The Diagnostic Program (I Units) - Precor C960 Service Manual

Procedure 2.2 - Running the Diagnostic Program (i Units)

Placing the C962i or C964i Treadmill in diagnostic mode causes the software to perform the
following operations:
a Test the LEDs mounted on the upper PCA;
b Provide the option of calibrating the lift system;
c Display the drive motor power bits;
d Display and test the heart rate function;
e Display the error code log;
f Provide a method of checking the operation of the keys on the electronic console;
g Test the circuit breaker trip function.
Procedure
1. Plug the power cord into the wall outlet, then position the safety switch at the green dot.
Turn on the treadmill by using the circuit breaker.
At the PRESS ENTER FOR PROGRAMS prompt, press keys RESET,5,1,7,6,5,7,6,1
2.
sequentially. The LED display test is initiated prompt on the electronic console. (The C964i
electronic console is shown in Diagram 2.4. The C962i electronic console is shown in
Diagram 2.5).
3. Watch the electronic console as the display test progresses. This test is programmed to
illuminate every LED on the display. It is necessary to watch the test as it proceeds to
determine if an LED does not illuminate. Press the ENTER key to proceed to the next test.
4. The lift calibration setup will be available if required. If you need to calibrate the lift proceed
with step 5, otherwise, press the ENTER key, go to step 6 and choose RECALIBRATE NO.
Using the INCLINE
5.
bottom front corner of the treadmill frame is 4.3 inches ± .05 inch. When the position is set
press the ENTER key. In step 6 of this procedure, choose RECALIBRATE YES.
6. You will be offered the to choice to either recalibrate the lift or to proceed without
recalibrating the lift. Press one of the
proceed without recalibrating the lift.
and INCLINE
keys set the treadmill so that the distance from the
keys to recalibrate the lift or one of the
C960 Series Commercial Treadmill
keys to
Page 12