Operation
Cutting Height Adjustment
The cutting height can be adjusted within two different
ranges. The lower cutting range is adjustable between
1-1/2" (3,8 cm) and 2-3/4" (6,9 cm). The upper cutting
range is adjustable between 2-3/4" (6,9 cm) and 4-1/2"
(11,5 cm).
Before adjusting the cutting height, you must first determine
the average cutting height. Depending on the range you
plan to use, it may be necessary to adjust which pulley the
deck drive belt runs in.
To Adjust the Cutting Range:
See your authorized dealer.
To Adjust the Cutting Height:
The cutting range must be adjusted to the correct range
before the cutting height can be adjusted. The cutting
height indicators will help you identify the cutting height.
1. Pull the cutting height adjustment handle (A, Figure 4)
up and out of the handle lock position (B) and crank the
handle clockwise to raise the deck to the desired cutting
height. Crank the handle counter-clockwise to lower
the deck to the desired cutting height. After the desired
cutting heights are achieved position the cutting height
adjustment handles into the handle lock position.
2. Repeat the process for the other side of the machine.
NOTE: Both sides of the cutter deck must be adjusted to the
same height to insure a proper cut.
16
B
Figure 4. Cutting Height Adjustment
A. Cutter Height Adjustment Handle
B. Handle Lock Position
C. Cutting Height Indicator
A
C
www.ferrisindustries.com