Maintenance - Jenn-Air JGR8855 User Manual

Maintenance 24
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Leveling Legs
The three-prong grounding plug offers protection against
shock hazards. DO NOT CUT OR REMOVE THE THIRD
GROUNDING PRONG FROM THE POWER CORD
PLUG.
If an ungrounded, two-hole or other type electrical outlet is
encountered, it is the personal responsibility of the appli-
ance owner to have the outlet replaced with a properly
grounded three-hole electrical outlet.
The range should be leveled when installed. If
the range is not level, turn the plastic leveling
legs, located at each corner of the How to
Remove Range
range, until range is level,
for Cleaning and Servicing
Follow these procedures to remove appliance for cleaning or
LEVEL_NGLEG servicing:
1. Shut off gas supply to appliance.
Oven Bottom
2. Disconnect electrical supply to appliance, if equipped.
3. Disconnect gas supply tubing to appliance.
Protect oven bottom against spillovers, especially acid or 4. Slide range forward to disengage range from the anti-tip
sugary spills, astheymaydiscolortheporcelainenamel. Use bracket. (See Installation Instructions for location of
the correct pan size to avoid spillovers and boilovers. Do not bracket.)
place aluminum foil directly on the oven bottom. 5. Reverse procedure to reinstall. If gas line has been discon-
The oven bottom on a conventional bake range may be nected, check for gas leaks after reconnection. NOTE: A
removed for easier cleaning. NOTE: The oven bottom on qualified servicer should disconnect and reconnect the gas
convection models is not removable. _ supply.
6. To prevent range from accidentally tipping, range must be
To remove: When cool, re- secured to the floor by sliding rear leveling leg into the
move the oven racks. Slide r
the two catches, located at [[_J[ 2"_ "'_/_q anti-tip bracket.
each rear comer of the oven H_¢£_//_
bottom, toward the front of _11_¢_
- Proportional Valve Adjustment
the oven. T4/ - for Surface Burners
Lift the rear edge of the oven II_/J i -- t 3i
bottom slightly, then slide it _" The Lo setting should produce a
back until the front edge of the oven bottom clears the oven stable flame when turning the
front frame. Remove oven bottom from oven. knob from Hi to Lo. The flame
To replace: Fit the front edge of the oven bottom into the should be 1/8 inch or lower and
oven front frame. Lower the rear of the ovenbottom and slide must be stable on all ports on Lo
the two catches back to lock the oven bottom in place, setting.
To adjust: Operate burner on Hi
for about five minutes to preheat
Electrical Connection
burner cap. Turn knob back to Lo; remove knob, and insert a
/._. _-_ _.(_ ] small screwdriver into the center of the valve stem. Adjust the
Appliances which require electrical flame size by turning adjustment screw in either direction,
power are equipped with a three-prong _ -_ I while holding the stem.
groundingplugwhichmustbeplugged _f_/_l (1__ I Flame must be of sufficient size to be stable on all burner
directlyintoaproperlygroundedthree-[[[ L ''_-2 I p°rts' Ifflame adjustment is needed' adjust ONLY °n the L°
hole 120 volt electrical outlet. I i _ setting. Never adjust flame size on a higher setting.
Always disconnect power to appliance before servicing. NOTE: All gas adjustments should be done by a qualified
servicer only.