Oven Light; Convection Motor Assembly; Oven Vent/Smoke Eliminator; Oven Cavity - Jenn-Air JJW8630 Service Manual

Electric wall oven
Hide thumbs Also See for JJW8630:
Table of Contents

Advertisement

Oven Light
Bulb can be replaced or accessed by turning
the lens counterclockwise
to remove the
entire oven light. The socket can be removed
by depressing the spring clips from the rear
of the light socket end pushing it into the
oven cavity.
A new oven light socket can be inserted
and
snapped into position by depressing the
spring clips and reattaching
in the original
position.
Convection
Motor Assembly
To access the motor assembly, remove the
three 1/4" hex screws from the convect
cover.
Remove the cover.
Remove three
additional
1/4" hex screws that secure the
convect motor assembly.
Pull convect
motor assembly into the oven cavity, dis-
connecting
the electricat quick-connect.
Reattach by returning
to original position
using reverse procedures.
OVEN VENT/SMOKE
ELIMINATOR
,
Remove oven vent and smoke eliminator
by using tabs on bottom of smoke elimi-
nator, turning counterclockwise
to disen-
gage the locking ears from the inner
insulation retainer.
2.
To remove the smoke eliminator, pull
down end align locking ears with notches
in oven cavity.
Reattach by reversing above procedures.
OVEN CAVITY
3.
Grasp the front flange of the oven liner
and gently pull forward to remove oven
liner from insulation and structure.
NOTE:
When replacing
oven cavity, use
pieces of sheet metal on sides and top of
oven liner to allow cavity installation
without tearing or removing insulation.
When the cavity is within two inches of
being in place, remove the sheet metal.
OVEN HINGE POCKETS
,
.
Remove oven door following
the steps
previously described in section on Oven
Door Removal.
Remove hex screws from the lower front
closure.
3.
From each side of the range, remove two
1/4" hex screws.
4.
Replace components
and reassemble.
.
.
All internal oven cavity components
must be removed
prior to oven cavity
removal.
Remove the five 1/4" hex screws from
the front flange of the oven liner. (Three
screws will be on the top and two on the
bottom.)
16009721
COMPONENT ACCESS
2-3
@1999 Maytag Appliances Sales Company

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents