Vermont Castings Resolute Acclaim 2490 Homeowner's Installation And Operating Manual page 15

Distance from the center of the Flue collar to the Wall in Top-exit installations
The information on this page is helpful in planning stove placement for top-exiting installations, particularly those instal-
lations with chimneys that pass through the ceiling. However, this is not a clearance chart. Final stove clearances must
adhere to the guidelines stated in the Clearance Chart on Page 12.
Resolute Acclaim: WiThoUT Stove and chimney connector heat Shields
Unprotected Surfaces
parallel installations
Side (A)
27¹⁄₂"
(699 mm)
A
*
* This distance, from the center of the flue collar to the front edge of the hearth, is the same for all installations on this page:
35" in the United States and 37" (940mm) in Canada.
Resolute Acclaim: WiTh Stove and chimney connector heat Shields
Unprotected Surfaces
parallel installations
Side (A)
27¹⁄₂"
(699 mm)
A
**To locate center of flue collar for corner installation, add 10¹⁄₂" (270mm) to the clearance distance from stove corner to wall.
Mark off the resulting distance from the corner along both walls. Next, measure the same distance from these two points out
from the walls. These last two measurements will meet at a point representing the center of the flue collar. Refer to the dia-
grams above.
2000893
corner
installations**
Rear (B) Corner (C)
26" 25¹⁄₂"
(660 mm) (648 mm)
B
C
ST608
Resolute Acclaim
corner
flue centerline
installations**
Diagrams
Rear (B) Corner (C) 1/01
17" 25¹⁄₂"
(432 mm) (648 mm)
B
C
ST608a
Resolute Acclaim
flue centerline
Diagrams
1/01
parallel installations
Side (D)
20¹⁄₂"
(521 mm)
D
*
parallel installations
Side (D)
20¹⁄₂"
(521 mm)
D
Resolute ® Acclaim Woodburning Stove
protected Surfaces
Rear (E)
15"
(381 mm)
E
protected Surfaces
Rear (E)
11"
(279 mm)
E
corner
installations**
Corner (F)
18¹⁄₂"
(470 mm)
F
ST608
corner
installations**
Corner (F)
18¹⁄₂"
(470 mm)
F
ST608a
15