Section 5 Maintenance - American Sportworks Trail Wagon TW400 Owner's Manual

SECTION 5
Transaxle Oil Change
Warm oil drains quickly and completely . Therefore, drain
used transaxle oil while transaxle housing is still warm as
follows:
1 . Park vehicle on a level surface, set park brake, turn off
ignition switch, and remove switch key .
2 . Place a suitable container below the transfer case to
catch used oil . Remove fill cap and drain plug .
3 . Allow used oil to drain completely and then reinstall
drain plug and tighten it securely .
4 . Dispose of used transaxle case oil in a manner that is
compatible with the environment . Do not throw used oil
in the trash, pour it on the ground, or down a drain .
5 . Fill transaxle housing with 20 oz . SAE 30W oil .
6 . Replace fill cap and tighten securely .
figure 5 .5B
17
Drive Belt
The dive belt is considered a wearable item . Replacement
intervals depend on vehicle use and environment . If your
belt is slipping you may need to replace it .
1 . Park vehicle on a level surface, set park brake, place
shifter in Neutral, turn off ignition switch, and remove
switch key .
2 . Remove the upper belt covers . (It is not necessary to
remove the bottom cover .
3 . "Walk" the belt off of the rear pulley as shown in Figure
5-6 .
figure 5 .6
4 . Install the new belt on the front pulley first and "walk" it
onto the rear pulley .
5 . Reinstall the belt guards . Figure 5-7 .
Attention: Failure to reinstall the belt guards
may void your warranty.
figure 5 .7
maintenance