assembly
Rear Fender Installation
1) Fenders installation Tilt the cargo bed up . Line up the
holes in the rear fenders with the square holes in the
bed . The raised rectangular surface on the fender
should be completely hidden under the bed . If not,
turn the fender around . Insert a ¼" x ¾" carriage bolt
through the bed and into the fender . Fasten with a ¼"
flat washer and a ¼" nylock . (If installing fenders on a
poly bed, you will use ¼" x 1" hex head bolts instead of
the carriage bolts .)
Seat Installation
1) Place back of seat base / underseat storage
tray over seat frame bar and lower seat base into
position .
SECTION 3
2) Secure underseat storage tray by pushing down firmly
around the plastic seat bottom wrap .
3) Place front tabs of seat bottom into the slots on the
underseat storage tray and lower seat into position .
Rear tabs of seat should fit into slots at the rear of seat
base / underseat storage tray .
12