Gas Conversions; Lp Gas Conversion - Jenn-Air W10394706A User Manual

18. Set the control console back into place on the cooktop. For a
proper fit, the flange of the control console must hook over
the lip on the front of the cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
IMPORTANT: Gas conversions from Natural gas to LP gas must
be done by a qualified installer.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
19. Check that the control console is flush with the top edge of
20. Replace the 2 screws on each side of the control console.
21. Push the cooktop back into place in the cutout.
22. Replace the control knobs.
23. Replace burner grates.
24. Plug in cooktop or reconnect power.
25. Test the flame by turning the control from LO to HI, checking

GAS CONVERSIONS

1. Turn the manual shutoff valve to the closed position.
2. Unplug cooktop or disconnect power.
To Convert Gas Pressure Regulator
1. Remove the access cap by using a wrench, turning the
2. Remove spring retainer from the cap by pushing against the
the cooktop.
A
A. Flush with top of cooktop
the flame at each setting.

LP Gas Conversion

A
A. To cooktop
B. Shutoff valve (closed position)
C. Gas supply line
access cap counterclockwise.
flat side of the spring retainer. Look at the spring retainer to
locate the "NAT" or "LP" position. Turn over the spring
retainer so the "LP" is showing on the bottom. Snap the
spring retainer back into the cap. Reinstall the cap onto the
regulator.
E D
A. Access cap
B. Gasket
C. Gas pressure regulator
B
C
A
B
C
D. LP position
E. NAT position
11