1-1. REAR COVER REMOVAL
1
Remove 18 screws from Rear Cover
(KLV-40V510A Only)
Remove 20 screws from Rear Cover
(KLV-46V510A Only)
2
Remove 1 screw from Side Jack position
3
Remove 1 screw from Terminal position
Remove 4 screws from Rear Cover
4
NOTE: The Rear Cover is attached to the Bezel Assembly with three small tabs.
Use caution when removing the Rear Cover not to damage these tabs.
1-2. SWITCH UNIT REMOVAL
1
Slide out Switch unit from Bezel
2
Disconnect 1 connector from HRT1 Board and remove 4 screws
KLV-40V510A/46V510A
SECTION 1: DISASSEMBLY
1
Bezel
2
Switch Unit
KLV-40V510A/46V510A
12