MXM-Assembly Fan (Optional): Dell Inspiron One 2305/2310 Service Manual
3
MXM-assembly fan cable
Replacing the MXM-Assembly Fan
1. Follow the instructions in
2. Align the screw holes on the MXM-assembly fan with the screw holes screw holes on the hex nut screw.
3. Adhere the silver foil to the MXM-assembly heat sink.
4. Replace the two screws that secure the MXM-assembly fan to the system board.
5. Connect the MXM-assembly fan cable to the connector (MXM FAN) on the system board.
6. Replace the system-board shield (see
7. Follow the instructions from
8. Replace the back cover (see
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain
inside the computer. Failure to do so may result in damage to the computer.
9. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
file:///T|/htdocs/systems/InsOne2310/sr/sm/mxm_fan.htm[7/25/2012 10:24:56 AM]
Before You
Begin.
Replacing the System-Board
step 4
to
step 5
in
Replacing the Front
Replacing the Back
Cover).
Shield).
Stand.