Connectivity; Sound Blaster Audigy 2 Card; Audio Inputs; Audio Outputs - Creative Sound Blaster Audigy 2 User Manual

Connectivity

Sound Blaster
Audigy 2 card

Audio Inputs

Audio Outputs

SB1394/FireWire Inter-
faces
The 6-pin SB1394/FireWire
connector/port has a 3 watt
maximum power output.
Connect only one high power
usage device such as the
IEEE 1394 hard disk and CD-
RW drive to this port unless
it is self-powered.
❑ One line-level analog Line input via stereo jack on rear bracket
❑ One mono Microphone analog input via stereo jack on rear bracket
❑ CD_IN line-level analog input via 4-pin Molex connector on card
❑ AUX_IN line-level analog input via 4-pin Molex connector on card
❑ TAD line-level analog input via 4-pin Molex connector on card
❑ CD_SPDIF digital input via 2-pin Molex connector on card
❑ DIGITAL OUT via 4-pole 3.5 mm minijack on rear bracket
❑ Three line-level analog outputs via 3.5 mm minijacks on rear bracket: front, rear,
and rear center/center/subwoofer Line-Outs 1, 2 and 3
❑ Stereo headphone (32-ohm load) support on Front Line-Out
❑ One 2 x 5 pin Internal SB1394/FireWire connector on card
❑ One 6-pin SB1394/FireWire port on rear bracket
General Specifications A-4