Operation 4
Performing a run 4.5
Stopping the run and viewing end parameter values
When the programmed time, volthours or milliamperehours for the last phase is
attained, the program will enter the END mode. It is also possible to break the run
manually by pressing STOP.
In both cases, the voltage, current and power will go to zero as indicated by the HV on
LED switching off. The end parameter values are displayed. Switch between total
elapsed time, integrated voltage or integrated current for all phases in the program
by
.
An alarm will sound at the end of each phase if selected in the program. You can stop
the alarm after the last phase by pressing STOP. A run cannot be continued after
pressing STOP. Disconnect the leads and proceed with post-electrophoretic techniques.
Since diffusion will begin as soon as the voltage is turned off, you should remove the gel
and begin staining, blotting or autoradiography immediately.
39
Electrophoresis Power Supply EPS 3501 XL Operating Instructions 28-9639-69 AA