Pptp - D-Link DIR-615 User Manual

Section 3 - Configuration
Choose PPTP (Pont-to-Pont-Tunnelng Protocol ) f your ISP uses a PPTP connecton. Your ISP wll provde you wth a username and password. Ths
opton s typcally used for DSL servces.
Address Mode:
Select Static f your ISP assgned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases,
select Dynamic.
PPTP IP Address:
Enter the IP address (Statc PPTP only).
PPTP Subnet Mask: Enter the Prmary and Secondary DNS Server Addresses (Statc
PPTP only).
PPTP Gateway:
Enter the Gateway IP Address provded by your ISP.
PPTP Server IP:
Enter the Server IP provded by your ISP (optonal).
Username:
Enter your PPTP username.
Password:
Enter your PPTP password and then retype the password n
the next box.
Reconnect Mode:
Select ether Always-on, On-Demand, or Manual.
Maximum Idle Time:
Enter a maxmum dle tme durng whch the Internet
connecton s mantaned durng nactvty. To dsable ths
feature, enable Auto-reconnect.
DNS Servers:
The DNS server nformaton wll be suppled by your ISP (In-
ternet Servce Provder.)
MTU:
Maxmum Transmsson Unt - you may need to change the MTU for optmal performance wth your specfic ISP. 1400 s the default MTU.
MAC Address:
The default MAC Address s set to the Internet port's physcal nterface MAC address on the Broadband Router. It s not recommended that you change the
default MAC address unless requred by your ISP. You can use the Clone.Your.PC's.MAC.Address button to replace the Internet port's MAC address wth the
MAC address of your Ethernet card.
D-Lnk DIR-615 User Manual

PPTP

21