Pppoe (Dsl) - D-Link DIR-615 User Manual

Section 3 - Configuration
Choose PPPoE (Pont to Pont Protocol over Ethernet) f your ISP uses a PPPoE connecton. Your ISP wll provde you wth a username and password.
Ths opton s typcally used for DSL servces. Make sure to remove your PPPoE software from your computer. The software s no longer needed and
wll not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down
Connection: menu.
Address Mode: Select Static f your ISP assgned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases,
select Dynamic.
IP Address: Enter the IP address (Statc PPPoE only).
User Name: Enter your PPPoE user name.
Password: Enter your PPPoE password and then retype the password
n the next box.
Service Name: Enter the ISP Servce Name (optonal).
Reconnection Mode: Select ether Always-on, On-Demand, or Manual.
Maximum Idle Time: Enter a maxmum dle tme durng whch the Internet
connecton s mantaned durng nactvty. To dsable ths
feature, enable Auto-reconnect.
DNS Addresses:
Enter the Prmary and Secondary DNS Server Addresses (Statc PPPoE only).
MTU:
Maxmum Transmsson Unt - you may need to change the MTU for optmal performance wth your specfic ISP. 1492 s the default MTU.
MAC Address:
The default MAC Address s set to the Internet port's physcal nterface MAC address on the Broadband Router. It s not recommended that you change the
default MAC address unless requred by your ISP. You can use the Clone.Your.PC's.MAC.Address button to replace the Internet port's MAC address wth the
MAC address of your Ethernet card.
D-Lnk DIR-615 User Manual

PPPoE (DSL)

20