TANDBERG 550 MXP User Manual page 34

D1374203_User_Manual_MXP_CCM
3.2.2 Selfview
The term "Selfview" means the outgoing image. In a normal call, using main
camera, this is the image of your self. The Selfview button toggles the images
between Far End, Selfview and Dual Video (if any).
How to use Selfview:
1. Outside a call, pressing the Selfview button will switch between the near end video and a
black screen on the main monitor.
2. In a point to point call, press the Selfview button once to switch from far end video to near
end video see a full screen picture of the outgoing video. Press Selfview again to go back
to normal.
3. In a point to point call with a dual video stream, the dual stream is displayed in the big
picture. Press the Selfview button to toggle to the Near End picture, then the Far End
picture, and finally back to the dual stream.
The above behavior is similar for both single monitor systems and dual monitor systems. Selfview
applies for the main monitor.
26